High octane. Following the lead of our heavy-duty Guru S HD reel, the Speedster S HD incorporates a full-cage design to capture line without failure. The full-cage design is the solution for thin-diameter running lines that are inclined to escape through spool/line-guard gaps. Speedster S HD and Speedster S have a taller and narrower format compared to other reels in our lineup.
The dimensions of structure and function inspire beauty. An enhanced spool machining technique—focusing material only where it’s needed—is the reason why this version is significantly lighter and higher performing than its predecessor. The HD version is a heavy-duty, full-frame reel.
| Item | Diameter | Width | Weight | Rod wt | Line capacity |
|---|---|---|---|---|---|
| Speedster -7+ | 100mm | 28mm | 140gr | WF 6-8 | 180 yds 20# |
| Speedster -9+ | 109mm | 32mm | 170gr | WF 8-10 | 220 yds 30# |
Do not remove the drag knob or the two-holed nut in the center of the drag knob for any reason.
Always ensure the Gland Cap is tight, especially before using the reel the first time or after reversing the retrieve direction. Be sure to periodically check that the cap is on securely; it should always be firmly tightened by hand, do not use a tool. The Gland Cap should seat completely on the drag cylinder when installed properly.
The drag system is meant to operate lubrication free. Do not use any type of oil or lubricant in or around the drag system. A small amount of WD-40 may be applied to the retrieve handle in order to remove any dirt build up between the handle and the handle shaft.
Freshwater Use: Occasionally rinse your reel thoroughly under fresh running water and wipe the spool and frame to remove any debris or dirt build up. Be sure to wipe down the spindle on the spool and keep it free of debris.
Saltwater Use:
Be sure to rinse the reel under fresh running water after every use in a salt environment. Occasionally rinse the drag by doing the following:
Remove the spool, unscrew the gland cap and remove the red and silver clutch assembly.
Rinse all components including the inside of the drag cylinder thoroughly with fresh running water.
Allow all components to dry completely before reassembly.
