Home

Remix Sublime

Remix Sublime

€ 219,00

Remix marries the best of pressure cast technologies and CNC machining to deliver a durable frame in a hard bright finish coupled with a cast aluminum spool with u-shaped arbor. Remix shares the same drag technology as all of our more expensive reels. Majority U.S. manufactured and assembled in Boise, Idaho.

  • Format: Large Arbor
  • Materials: Machined Aluminum,
    stainless steel
  • Finish: Type 2
Article #:N/A
Availability: Yes
Categories:  WW-L , WW-L LAMSON REMIX , SUBLIME

Share:

Item Diameter Width Weight Rod wt Line capacity
Remix -3+ 85mm 25mm 121gr WF 2-4 WF4 100 yds 20#
Remix -5+ 92mm 25mm 129gr WF 4-6 WF6 100 yds 20#
Remix -7+ 98mm 29mm 156gr WF 6-8 WF8 200 yds 20#
Remix -9+ 118mm 34mm 235gr WF 8-10 WF10 250 yds 30#

  1. Do not remove the drag knob or the two-holed nut in the center of the drag knob for any reason.

  2. Always ensure the Gland Cap is tight, especially before using the reel the first time or after reversing the retrieve direction. Be sure to periodically check that the cap is on securely; it should always be firmly tightened by hand, do not use a tool. The Gland Cap should seat completely on the drag cylinder when installed properly.

  3. The drag system is meant to operate lubrication free. Do not use any type of oil or lubricant in or around the drag system. A small amount of WD-40 may be applied to the retrieve handle in order to remove any dirt build up between the handle and the handle shaft.

  4. Freshwater Use: Occasionally rinse your reel thoroughly under fresh running water and wipe the spool and frame to remove any debris or dirt build up. Be sure to wipe down the spindle on the spool and keep it free of debris.

Saltwater Use:

Be sure to rinse the reel under fresh running water after every use in a salt environment. Occasionally rinse the drag by doing the following:

  1. Remove the spool, unscrew the gland cap and remove the red and silver clutch assembly.

  2. Rinse all components including the inside of the drag cylinder thoroughly with fresh running water.

  3. Allow all components to dry completely before reassembly.

You May Also Like